Page 149 - 2017-Swift-Group-Motorhomes-Handbook-web
P. 149

ALDE BOILER

FITTED EQUIPMENT  Draining Freshwater                                Heat Transfer Fluid
                  1. Switch off the water pump.
                                                                     The central heating system is filled with heat
                  2. Open all water taps, showers, etc.              transfer fluid (HTF), a solution of 50% ethylene
                                                                     glycol antifreeze and 50% water.
                  3. Open the safety/drain valve by lifting the
                  yellow tab (Fig 1 [M]), or by turning the blue     The antifreeze manufacturer will have a
                  knob (Fig 1 [K]) 90°.                              maximum water hardness recommendation.
                                                                     Read the product label or contact the product
                  4. The system will drain directly below the        manufacturer for details.
                  vehicle through the clear plastic hose on the
                  safety/drain valve. Check that all water has        Note: For re-filling Alde recommends
                  emptied out (7–10 litres). Leave the valve in the   antifreeze meeting VAG G12++ or G13
                  open position until the next time the hot water     specification, and deionised water (0 ppm).
                  cylinder is used.
                                                                     50:50 ethylene glycol antifreeze and water
                   Note: Check that the red breather valve (Fig      will protect against frost down to -35–37 °C.
                   1[N]) is allowing air to enter the hot water      A refractometer and/or hydrometer can be
                   cylinder, when it is being drained, and that      used to measure the strength of the antifreeze
                   the clear plastic hose is not obstructed.         solution.

                  Figure 1                                           Corrosion protection will vary depending on
                                                                     the lifespan of the antifreeze. Read the product
                  Open the manual safety/drain valve                 label or contact the product manufacturer for
                                                                     details.

                                                                      ! WARNING: Always replace the HTF in

                                                                      accordance with the antifreeze product’s
                                                                      lifespan. If in any doubt, replace the HTF
                                                                      after 2 years.

                  Opening the safety/drain valve                     The corrosion inhibitors found in ethylene
                                                                     glycol antifreeze may not be cross-compatible.
                                                                     When topping up or replacing the HTF, ensure
                                                                     the new antifreeze is compatible with the
                                                                     current antifreeze product. Read the product
                                                                     label or contact the product manufacturer for
                                                                     details.

                                                                      ! WARNING: As a rough guideline,

                                                                      blue and red antifreeze products are not
                                                                      compatible with each other, but VAG G12++
                                                                      and G13 spec antifreeze (purple/magenta) is
                                                                      compatible with both.

                                                                     Failure to fill with suitable HTF may result in
                                                                     severe damage to your Alde system, and is
                                                                     not covered under warranty.

136
   144   145   146   147   148   149   150   151   152   153   154