Page 72 - 2017-Swift-Group-Motorhomes-Handbook-web

WATER FAULTS

Water SERVICES

Fault Cause Remedy
Water flows Check and re-route if necessary
from hot Cold water pipe kinked
tap but has preventing flow Disconnect pipes after 1st connector and
reduced flow check up to tap
from cold Blockage in cold pipe line Refer to installation instructions
Disconnect and inspect
Reduced flow Cold tap not connected Check battery state of charge,
from both hot refer to electrical supply note
and cold taps Cold tap failed or blocked
Disconnect and check that they have at least
Reduced flow Battery condition low 1/4” (6.3mm) bore
from either tap causing pump to Refer to pump servicing instructions
If pump motor run slowly Dismantle and clean if necessary
runs steadily
and will not If new taps have been fitted Check and re-route if necessary
stop they may be restricting flow
Check all water connections
Pump needs servicing Check and re-route if necessary
Use taps of equal bore size
Partially blocked pump filter Check that there is water in the container
or in-line filter, if fitted Adjust switch and/or re-charge battery
Check all connections in pipework
Pump outlet pipe kinked
restricting flow

Water leak

Pipe kinking restricting flow

Bore size difference in taps

Battery voltage may be
too low (below 10.5 volts)

59