Page 88 - 2017-Swift-Group-Motorhomes-Handbook-web
P. 88

• L eisure battery, the leisure battery voltage and charging or discharging      ELECTRICS
             current is displayed. Use the select button to toggle the display, with
Menu Tree    voltage on the main display whilst current (in or out of the battery is
             shown on the bargraph and vice-versa, current on the main display and
             voltage on the bargraph.

           • Vehicle battery, when connected the vehicle battery voltage and
             charging or discharging current is displayed. Use the select button to
             toggle the display, with voltage on the main display whilst current (in or
             out of the battery is shown on the bar-graph and vice-versa, current on
             the main display and voltage on the bar-graph.

           • Solar Power, the charging current from the solar panel along with the
             voltage of the battery it is charging is displayed. Use the select button
             to toggle the display, with voltage on the main display whilst current is
             shown on the bargraph and vice-versa, current on the main display and
             voltage on the bargraph.

           • S elect Battery, press the select button toggles between the Leisure
             and Vehicle batteries as the power source (or battery to be charged). The
             selected battery is shown in the header area.

           • T ank-Fill on/off, is not applicable to motorhomes and will not appear on
             the menu.

           • T ank Heaters on/off, this feature enables or disables the automatic
             Fresh & Waste water tank frost protection system. Tank heating will start
             when the tank level is 25% or higher and the external temperature is
             under 2 degrees C.

           • A C Limit, the AC current limiter, when enabled, will monitor the incoming
             AC current and if the set limit is reached the 230V heating element within
             the heating system will be temporarily turned off until the current falls
             below the set limit. Use the select button to set the limit or to turn the
             feature off. The AC Limit icon in the header indicated that a limit is set and
             will flash if the limiter is active.

           • Temperature & Humidity, Pressing the select button scrolls through the
             internal temperature, internal humidity & external temperature readings.
             Please note that due to the location of the internal temperature sensor
             there may be slight differences to the temperature shown on the heating
             system.

           • Dimmer %, this display shows the lighting dimming level and is adjusted
             in 5% increments. The display commences where the level was last set.
             Press the select button to increase the level up to 100% and then back
             down again to 5%. Pressing the dimming button on the control panel
             immediately shows this dimming value.

           • H eater Settings, this sub menu allows the heater controls and
             associated settings to be adjusted. A full explanation of the controls can
             be found in the heater section.

           • System Settings, this sub menu allows a number of system features to
             be configured like the Clock, Date, Key beep, Backlight time, LED time,
             Tank Alarms, Bluetooth Pairing etc.

                                                                                             75
   83   84   85   86   87   88   89   90   91   92   93