Page 139 - 2017-Swift-Group-Motorhomes-Handbook-web
P. 139
FITTED EQUIPMENTALDE CONTROL PANEL Navigation Arrows
Day Mode is enabled, but T here are four screens in the
may or may not be active, Settings Menu. The up/down
depending on the time and arrows allow you to navigate
day. between them.
Load Monitor is enabled and Night Mode (requires Clock to
an amp limit is set. be set)
(model specific)
A llows you to programme the
Settings Menu boiler to automatically change
Press the Tool Button to access the Settings and select settings at night. Set
Menu from the Main Menu. Lower level a start and stop time for the
functions can be accessed by from these night-time period. Set a day of the
screens by pressing the buttons. NB: If a week, or “All” for the same daily
function is not available its button is greyed programme. You can also define:
out.
• Desired room temperature
To return to the Main Menu, press
the MENU button. • Invert Standby Screen
Delayed Start/Cycle (requires • Hot water ignore
Clock to be set)
•Temperature sensor (if discrete
A llows you to programme the room temperature sensors are
boiler to start at a specified time connected)
and day, weekly. It will provide
heating using the last saved • AC Quiet Mode (if Truma Aventa
settings for 24 hours, before Comfort air-conditioning unit is
automatically shutting down connected)
again. This is recommended for
airing the vehicle over winter if Day Mode (requires Clock to
stored locally and hooked up be set)
to 230 V power. Once Delayed
Start/Cycle is enabled, the system A llows you to programme the
should be shut down by pressing boiler to automatically change and
the Power button. select settings during the day.
Set a start and stop time for the
C lock day-time period. Set a day of the
The clock must be set for week, or “All” for the same daily
programmable functions to programme. You can also define:
activate at the correct time/day. If
12 V power is lost, the clock will • Desired room temperature
reset.
• Hot water ignore
TiP! The optional Alde 3010-414 battery
backup uses two AA batteries and allows Temperature Offset
the clock memory to be stored even if
12 V power is lost. R ecalibrate the room temperature
displayed by the control panel in
126 0.5 °C increments. If an outdoor
temperature sensor is connected,
this can also be recalibrated.
Return
Return to the previous menu.
